V585ME48-LF catv headend test equipment downconvertors 10 19 43 950 0-15 81 -98 -30 <3 <2 500 50 -40 to 80 oscillation frequency range phase noise @ 10 khz offset (1 hz bw, typ.) harmonic suppression (2nd, typ.) tuning voltage tuning sensitivity (avg.) power output load impedance input capacitance (max.) pushing pulling (14 db return loss, any phase) operating temperature range package style mini-16-l mhz dbc/hz dbc vdc mhz/v dbm pf mhz/v mhz c vdc ma supply voltage (vcc, nom.) supply current (icc, typ.) all specifications are typical unless other wise noted and subject to change without notice. phase noise (1 hz bw, typical) ? z-communications, inc. all rights reserved page 1 voltage controlled oscillator features applications performance specifications value units power supply requirements application notes 950 2050 - mhz ? frequency range: ? tuning voltage: 0-15 vdc - style package mini-16-l ? ? ? ? a1 rev ? an-100/1 : mounting and grounding of vcos ? an-102 : proper output loading of vcos ? an-107 : how to solder z-comm vcos notes: 9939 via pasar ? san diego, ca 92126 tel (858) 621-2700 fax (858) 621-2722 - 2050 offset (hz) (f) (dbc/hz)
845 915 985 1055 1125 1195 1265 1335 1405 1475 1545 1615 1685 1755 1825 1895 1965 2035 2105 0123456789101112131415 0 1 2 3 4 5 6 7 876 1084 1232 1359 1478 1591 1701 1810 1919 2025 2120 low cost - high performance voltage controlled oscillator ? z-communications, inc. page 2 printed in the u.s.a. V585ME48-LF tuning curve, typ. power curve, typ. page 2 physical dimensions c c c 80 -40 25 c 25 0.475 0.000 0.025 0.500 0.405 0.305 0.205 0.105 0.185 0.285 0.385 0.500 0.115 0.215 0.315 0.415 0.420 0.320 0.475 0.500 0.000 0.025 0.220 ground plane solder plated bottom view p1 p3 p2 .037 see note 3 typical of all pads .026 .031 .052 .114 .070 0.085 0.115 tabs range: see note 5. (4 places) detail a p1=vt p2=rf out p3=vcc .130 .034 0.000 -.005 .465 .070 typ .150 typ mini-16-l 415-0061 rev. d (drawing not to scale) see detail 'a' notes: the inside radius of all 16 half holes at the perimeter of the board are plated to provide a surface for the attachment of the vco to a pcb, in 13 locations, with 3 pads being used for electromechanical interface. 2. the surface of the shield is tin plated and may be soldered to. the shield's 3. the ground plane is ground and attaches to a ground track on the upper side of the board as well as the shield by pth. 1. 16 solder locations required. base metal is cold rolled steel. .xxx= .010 tolerances 4. unless otherwise noted all dimensions are in inches. 5. unless otherwise noted all tolerances are as follows: tuning voltage (vdc) frequency (mhz) power output (dbm) frequency (mhz)
|
